Clutch Cover Rebuild

Scooter Mercato is Your Source for:
Vintage Vespa Parts
Modern Vespa Parts

Cart Summary

-	Your Cart is Empty
-	View Cart

-	Tech Tips
+	Scooter Clubs



	Small Flat Head Screwdriver Pick Tool Spring Puller 14MM Wrench
	Inspect the Clutch Cover for any cracks or any defects on the surface where it mounts to the engine case
	Remove the Brass Plunger
	Remove the O-Ring
	Remove the Oil Breather
	Inspect it for any blockage you should be able to blow through it with compressed air
	Using a Pry Bar Remove the Spring
	Pull out the Clutch Arm
	Note the O-ring on the bottom of the arm. REPLACE this (it is a cause of Oil Leaks that ruins your moms driveway) It is included in you Engine Rebuild Gasket Set
	Pull the Inner Lever
	Remove the Spring

	Clean All the components with the degreaser of your choice (I prefer a parts washer with mineral spirits)
	Here is that O-Ring we talked about pull it off with a pick and REPLACE it
	Note the Inner Lever has one rounded corner The Clutch Arm has a matching shape
	Install the Spring Hook one end around the tab on the Clutch Cover
	Install the Clutch Arm making sure it lines up with the Inner Lever properly
	Put it in the vice
	Using the Spring Puller hook the other end around the tab on the Clutch Arm
	This is what it should look like.
	Install the breather 14MM

	A little bit of Grease
	Install the Brass Plunger
	Finally install the O-Ring